Well I filmed a tape went to batch capture a bunch of logged clips and it's a mess. The audio is out of sync, wrong clips captured, errors etc.. I'm wondering if this has something to do with broken timecode and what's the best setup or way to go about recording without breaking timecode and keeping everything on one single timecode. Thanks.
Not sure exactly what caused that bad batch capture, but if you don't remove the tape from the camera, you shouldn't end up with broken timecode. If you do remove the tape, you can use the "end search" function to cue the tape up to a few frames before the last scene currently recorded on the tape, to allow for continued timecode from where the last recording left off.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment